| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A security vulnerability has been detected in libimobiledevice up to 1.4.0. Impacted is the function afc_file_open of the file src/afc.c of the component AFC File Handler. The manipulation of the argument bytes leads to out-of-bounds read. It is possible to initiate the attack remotely. The exploit has been disclosed publicly and may be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| A vulnerability was identified in libimobiledevice up to 1.4.0. This affects an unknown part of the file src/afc.c of the component AFC. Such manipulation leads to heap-based buffer overflow. The attack can be executed remotely. The exploit is publicly available and might be used. The vendor was contacted early about this disclosure but did not respond in any way. |
| The GiveWP WordPress plugin before 4.19.0.1 does not restrict the currency of a donation to the one the site or form accepts, while comparing its amount limits as bare numbers, allowing unauthenticated users to make donations below a form's configured minimum or fixed amount. |
| A flaw was found in BusyBox dpkg. The write_status_file() function does not reset a field cursor between package stanzas. When two packages are removed in a single invocation and the first stanza is larger than the second, the second package stanza can be dropped from the status file, causing limited data corruption. |
| SOEM version 2.0.0 and earlier contains multiple vulnerabilities in frame processing where a malicious device can cause the master to read data outside allocated buffers. The software uses length and offset values from device messages without validating them against buffer sizes. This can cause the master to access invalid memory locations, potentially disclosing sensitive information or causing crashes. |
| SOEM version 2.0.0 and earlier contains a vulnerability in multi-segment data transfers where a malicious device can overflow memory buffers. The software checks the total size only once at the beginning, but doesn't track the cumulative size as multiple segments arrive. An attacker can declare a small initial size to pass validation, then send additional segments that exceed the allocated buffer. This allows the attacker to write controlled data beyond buffer boundaries, potentially enabling code execution. |
| SOEM version 2.0.0 and earlier contains vulnerabilities where a malicious device on the network can send specially crafted messages that cause the master to write data outside allocated memory boundaries. The software performs arithmetic on message length values without proper validation, allowing negative or extremely large values to bypass safety checks. This can corrupt memory and potentially allow an attacker to execute arbitrary code on the master system. |
| In the Linux kernel, the following vulnerability has been resolved:
md/raid5: let stripe batch bm_seq comparison wrap-safe
Once the 32-bit seq wraps, a newer bm_seq can look smaller
than old, so .. covert to wrap-safe calculate way. |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_scmi: Validate SENSOR_UPDATE payload size
SENSOR_UPDATE carries one or more sensor readings after the fixed
notification header. The parser derives the expected reading count
from the sensor description, but it did not verify that the received
payload contains those entries before parsing them.
Reject truncated update notifications before reading the variable
array. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: validate deauth frame length before reason access
ieee80211_rx_mgmt_deauth() reads the deauth reason code before checking
that the fixed field is actually present in the received frame.
Validate the deauth frame length first and only then read the reason
code. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211_hwsim: reject undersized HWSIM_ATTR_TX_INFO
hwsim_tx_info_frame_received_nl() casts the HWSIM_ATTR_TX_INFO payload
to a struct hwsim_tx_rate * and unconditionally reads
IEEE80211_TX_MAX_RATES entries (8 bytes) from it. The policy only bounds
the attribute from above (NLA_BINARY .len is a maximum) and the op sets
GENL_DONT_VALIDATE_STRICT, so a short or zero-length attribute is
accepted and the loop reads past the payload.
Require the exact length in the policy, so a malformed attribute is
rejected before the handler runs. |
| Starman versions before 0.4019 for Perl allow CPU exhaustion via quadratic regex backtracking when parsing chunked request bodies.
Starman decodes chunked request bodies before calling the application, matching each chunk-size line with `s/^(([0-9a-fA-F]+).*\015\012)//`. A line of hex digits followed by a bare LF and then CRLF never matches, because `.` does not match LF, and each failed attempt backtracks in time quadratic in the length of the hex run. Nothing limits the length of the line.
A remote attacker can exhaust worker CPU by sending such requests to any route. |
| telnetd in GNU inetutils through 2.7 allows an out-of-bounds write in the LINEMODE SLC (Set Local Characters) suboption handler because add_slc does not check whether the buffer is full. |
| TOTOlink A3600R v5.9c.4959 contains a buffer overflow vulnerability in the setAppEasyWizardConfig interface of /lib/cste_modules/app.so. The vulnerability occurs because the rootSsid parameter is not properly validated for length, allowing remote attackers to trigger a buffer overflow, potentially leading to arbitrary code execution or denial of service. |
| ImageMagick before 6.9.13-58 and 7.x before 7.1.2-33 contains a heap-based buffer overflow in the X11 animate operation when processing crafted images. Attackers can supply a malicious image that, when a user runs an X11 animate operation on it, overwrites heap memory and can crash the application. |
| vLLM from 0.22.0 before 0.24.0 contains an improper input validation vulnerability in the Rust gRPC converter that allows remote attackers to bypass max_logprobs limits via CandidateTokens.top_n. Attackers can send Generate or GenerateStream requests with oversized or integer-wrapping top_n values to trigger torch.topk failures that terminate EngineCore. |
| Vulnerability in NetScaler ADC and NetScaler Gateway.
This issue affects ADC: from 14.1 through 73.32 and from 13.1 through 63.21; Gateway: from 14.1 through 73.32 and from 13.1 through 63.21. |
| ImageMagick before 6.9.13-58 and 7.x before 7.1.2-33 incorrectly parses delegate invocations, which can allow an executable blocked in policy.xml to still run. An attacker who gets ImageMagick to process input that triggers a delegate invocation can bypass the administrator-defined policy and execute the blocked program. |
| A flaw was found in GIMP’s X cursor (XMC) thumbnail loader. When GIMP generates a thumbnail for a crafted XMC file, it allocates a pixel buffer using a width * height size computed in 32-bit signed arithmetic. If that product overflows, the allocation is smaller than the true image extent. A subsequent GEGL buffer read uses the unwrapped dimensions and performs an out-of-bounds read on the heap, after integer overflow in the size calculation. This can crash GIMP or corrupt process memory. |
| Heap-based buffer overflow in Windows iSCSI allows an unauthorized attacker to execute code over a network. |
