| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| CAI Content Credentials is affected by an Improper Input Validation vulnerability that could result in a Security feature bypass. An attacker could leverage this vulnerability to bypass security measures and gain unauthorized write access. Exploitation of this issue does not require user interaction. |
| In the Linux kernel, the following vulnerability has been resolved:
nvme-tcp: fix host memory disclosure on R2T for a read command
nvme_tcp_handle_r2t() does not check the direction of the request the
R2T refers to. A malicious controller can send an R2T for a READ and
the host will answer it: nvme_tcp_setup_h2c_data_pdu() builds the
H2CData header and nvme_tcp_try_send_data() sends the request's data
buffer. That buffer is the READ destination, so its contents go to the
controller.
The command then completes normally and nothing is logged.
Against a test controller that answers every READ with an R2T, a 4096
byte buffered read returned all 4096 bytes, split over two R2Ts. The
pages contained stale kernel data, including an array of struct page
pointers.
Reject an R2T for a request that is not a write. |
| In the Linux kernel, the following vulnerability has been resolved:
can: j1939: transport: j1939_session_fresh_new(): initialize receive buffer
Zero the allocated buffer in j1939_session_fresh_new() to ensure it
contains no residual data.
While there is a potential performance impact if users allocate maximum
sized ETP buffers, most real-world use cases are not noticeably affected
since the maximum known buffer size is typically around 65K.
[mkl: add Message-ID] |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nf_conntrack_irc: fix parse_dcc() off-by-one OOB read
parse_dcc() treats data_end as an inclusive end pointer, but its only
caller passes data_limit = ib_ptr + datalen, which points one past the
last valid byte.
The newline search loop iterates while tmp <= data_end, so when no
newline is present, *tmp is read at tmp == data_end, one byte beyond
the region filled by skb_header_pointer().
irc_buffer is kmalloc'd as MAX_SEARCH_SIZE + 1 bytes and datalen is
capped at MAX_SEARCH_SIZE, so the stray read does not fault. The byte
is uninitialized or stale; if it contains an ASCII digit, simple_strtoul
will consume it and produce a wrong DCC IP or port in the conntrack
expectation. The extra allocation byte is also a fragile guard: if the
cap or allocation size changes, this becomes a real out-of-bounds read.
Change the loop and its post-loop check to use strict less-than,
consistent with the caller's exclusive-end convention. Update the
function comment accordingly. |
| In the Linux kernel, the following vulnerability has been resolved:
net/sched: cls_u32: skip hash tables in u32_bind_class()
u32_walk() enumerates both struct tc_u_hnode and struct tc_u_knode
through the walker callback. u32_bind_class() unconditionally casts the
passed fh to tc_u_knode and accesses &n->res, so when fh is actually a
tc_u_hnode, which has no tcf_result member, this results in a
slab-out-of-bounds read of res->classid in tc_cls_bind_class().
The issue can be reproduced with the following commands:
tc qdisc add dev lo root handle 1: hfsc
tc class add dev lo parent 1: classid 1:1 hfsc sc rate 1000kbit
tc filter add dev lo parent 1:1 protocol ip prio 1 u32 match u32 0 0 flowid 1:1
tc class add dev lo parent 1: classid 1:2 hfsc sc rate 2000kbit
Fix this by skipping hash tables via the TC_U32_KEY(handle) check. |
| In the Linux kernel, the following vulnerability has been resolved:
net/atm: fix slab-out-of-bounds read in vcc_setsockopt()
vcc_setsockopt() contained an ineffective optlen check:
if (__SO_LEVEL_MATCH(optname, level) && optlen != __SO_SIZE(optname))
return -EINVAL;
If __SO_LEVEL_MATCH(optname, level) evaluated to false (e.g. if the caller
passed a mismatched level), the length check optlen != __SO_SIZE(optname)
was short-circuited and bypassed. Execution then fell through to switch(optname),
calling copy_from_sockptr() assuming optval contained sufficient space.
Furthermore, even if level matched, a cgroup BPF setsockopt filter could shrink
optlen after entry. Because copy_from_sockptr() on kernel pointers uses memcpy(),
this leads to a KASAN slab-out-of-bounds read when optlen is smaller than the
expected structure size.
Fix this by using copy_safe_from_sockptr(), which unconditionally validates
that optlen is at least the expected size before copying. Also change the local
'value' variable type from 'unsigned long' to 'int' so that SO_SETCLP matches
its sizeof(int) ABI encoding on 64-bit systems. |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: fix Route Information option length validation
rt6_route_rcv() validates the Route Information option (RFC 4191) length
against the prefix length, but both checks are off by one.
rinfo->length is the ND option length in units of 8 octets and it
*includes* the 8-byte option header, so an option carrying N bytes of
prefix has length == 1 + N/8. RFC 4191 section 2.3 requires length 3
when Prefix Length is greater than 64, and 2 or 3 when it is greater
than 0. The code accepts length >= 2 and length >= 1 respectively.
ipv6_addr_prefix() then copies prefix_len/8 bytes out of rinfo->prefix,
so a Router Advertisement with (prefix_len=128, length=2) or
(prefix_len=64, length=1) makes the kernel read up to 8 bytes past the
end of the option. Those bytes end up in the prefix of the route that
gets installed, so they are visible to userspace:
# RA with a Route Information option (prefix_len=128, length=2)
# followed by a source link-layer address option, 01 01 de ad be ef ca fe
$ ip -6 route show
2001:db8:dead:beef:101:dead:beef:cafe via fe80::1234 dev veth0 proto ra
^^^^^^^^^^^^^^^^^^ the next option, read out of bounds
When the Route Information option is the last one in the packet, those
eight bytes come from the skb tail room instead.
Reject the option lengths RFC 4191 does not allow. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_hashlimit: validate hashtable supports XT_HASHLIMIT_RATE_MATCH
The XT_HASHLIMIT_RATE_MATCH flag mode changes the semantics of the
dsthash_ent structure which represents an entry in the hashtable. There
is a union area which uses a different layout to express the rate match
mode.
Update .checkentry path to validate the XT_HASHLIMIT_RATE_MATCH mode
flag is requested by two or more different rules that refer to the same
hashtable. Otherwise, uninitialized access to the burst field in the
union is possible.
Reject the use of the XT_HASHLIMIT_RATE_MATCH mode flag if set on by
revision less than 3 too. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: rtw89: fix wrong pci_get_drvdata type in AER handlers
rtw89 stores an ieee80211_hw pointer via pci_set_drvdata() at probe
time, but io_error_detected() and io_resume() retrieve it as a
net_device pointer. This causes netif_device_detach/attach to
operate on an ieee80211_hw struct, reading and writing at wrong
offsets. The adjacent io_slot_reset() already does it correctly.
Use ieee80211_stop_queues/wake_queues instead, consistent with
every other queue stop/start path in the driver.
Tested on RTL8852CE by calling the handlers from a test module
before and after the fix. |
| Open Zaak is an open-source data and services layer for Dutch case-oriented working. From 1.13.0 until 1.27.2, 1.28.2, and 1.29.0, _import_document_row in src/openzaak/components/documenten/tasks.py uses the attacker-controlled bestandspad CSV field without ensuring that the resolved path remains under IMPORT_DOCUMENTEN_BASE_DIR. A client with an all-authorizations application token can supply an absolute or parent-traversal path to a file readable by the Celery service account. The worker copies that file into document storage, allowing its contents to be retrieved through the normal document download API and exposing server secrets or other private files. This issue is fixed in versions 1.27.2, 1.28.2, and 1.29.0. |
| The Visual Form Builder WordPress plugin through 3.1 does not perform an authorization check before displaying recent form submission data in a dashboard widget, allowing any authenticated user (Subscriber and above) to read other users' submitted contact information, including names, email addresses, form titles and timestamps. |
| The Salon Booking System WordPress plugin before 10.31.3 does not restrict several of its booking REST API routes to users with the appropriate capability, allowing any authenticated user such as a subscriber to read every customer's booking records, including their personal data. |
| The Product Delivery Date for WooCommerce WordPress plugin before 3.3.2 does not perform a capability check before disclosing order details through its calendar view AJAX actions, allowing users with a role as low as Contributor to view other customers' order information. |
| Heap-based buffer overflow in Microsoft Office Excel allows an unauthorized attacker to execute code over a network. |
| Claude Agent SDK is a Python SDK for Claude Code. Prior to 0.2.121, the resume option is passed to the Claude CLI as a separate token without validation, so a dash-leading value is parsed as an independent CLI flag. An attacker can inject the --mcp-config flag to define a stdio MCP server, causing arbitrary command execution at CLI startup outside the SDK permission controls. The issue is exploitable when an application passes untrusted input as the session ID to resume. This issue is fixed in version 0.2.121. |
| Observable discrepancy in Active Directory Federation Services (AD FS) allows an unauthorized attacker to disclose information over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: xt_u32: reject invalid shift counts
u32_match_it() executes rule-supplied shift operands on a 32-bit
value. A malformed u32 rule can provide a shift count of 32 or more,
triggering an undefined shift out-of-bounds during packet evaluation.
Validate XT_U32_LEFTSH and XT_U32_RIGHTSH operands in
u32_mt_checkentry() and reject malformed rules before they reach the
packet path. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: SOF: ipc3-control: Fix heap overflow in bytes_ext put/get
The ipc_control_data buffer is allocated as kzalloc(max_size), where
max_size covers the entire struct sof_ipc_ctrl_data including its
flexible array payload. However, the bounds checks in bytes_ext_put
and _bytes_ext_get compared user data lengths against max_size
directly, ignoring that cdata->data sits at an offset of
sizeof(struct sof_ipc_ctrl_data) bytes into the allocation.
This allowed writing up to sizeof(struct sof_ipc_ctrl_data) bytes past
the end of the heap buffer from unprivileged userspace via the ALSA TLV
kcontrol interface, and similarly allowed over-reading adjacent heap
data on the get path.
Fix all bounds checks to subtract sizeof(*cdata) from max_size so they
reflect the actual space available at the cdata->data offset. Also fix
the error-path restore in bytes_ext_put which wrote to cdata->data
instead of cdata, causing the same overflow. |
| FreeRDP from 3.30.0 before 3.32.0 contains a resource exhaustion vulnerability in the rdpecam client that lets malicious RDP servers request unadvertised camera media types. Attackers can send a StartStreamsRequest with oversized dimensions to force large pending-sample allocations and reconfigure the local camera through the HAL. |
| Improper verification of cryptographic signature in Windows Update Stack allows an authorized attacker to perform spoofing locally. |
