| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
drm/virtio: fix dma_fence refcount leak on error in virtio_gpu_dma_fence_wait()
dma_fence_unwrap_for_each() internally calls dma_fence_unwrap_first()
which does cursor->chain = dma_fence_get(head), taking an extra
reference. On normal loop completion, dma_fence_unwrap_next()
releases this via dma_fence_chain_walk() -> dma_fence_put().
When virtio_gpu_do_fence_wait() fails and the function returns early
from inside the loop, the cursor->chain reference is never released.
This is the only caller in the entire kernel that does an early return
inside dma_fence_unwrap_for_each.
Add dma_fence_put(itr.chain) before the early return. |
| Dell Server Hardware Manager, versions prior to 3.2.2, contains an Improper Access Control vulnerability. A low privileged attacker with local access could potentially exploit this vulnerability, leading to Elevation of privileges. |
| In the Linux kernel, the following vulnerability has been resolved:
drivers/base/memory: fix memory block reference leak in poison accounting
memblk_nr_poison_inc() and memblk_nr_poison_sub() look up a memory block
via find_memory_block_by_id(), which acquires a reference to the memory
block device.
Both helpers use the returned memory block without dropping that
reference, leaking the device reference on each successful lookup. Drop
the reference after updating nr_hwpoison. |
| A vulnerability in the management web server of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker with high privileges to execute configuration commands on an affected system.
This vulnerability exists because access to HTTPS endpoints is not properly restricted on an affected device. An attacker could exploit this vulnerability by sending specific messages to the affected HTTPS handler. A successful exploit could allow the attacker to perform configuration changes on the affected system, which should be configured and managed only through Cisco Firepower Management Center (FMC) Software. |
| In the Linux kernel, the following vulnerability has been resolved:
batman-adv: tp_meter: fix tp_vars reference leak in receiver shutdown
The receiver shutdown timer handler, batadv_tp_receiver_shutdown(), is
responsible for releasing the tp_vars reference it holds. However, the
existing logic for coordinating this release with batadv_tp_stop_all() was
flawed.
timer_shutdown_sync() guarantees the timer will not fire again after it
returns, but it returns non-zero only when the timer was pending at the
time of the call. If the timer had already expired (and
batadv_tp_stop_all() would unsucessfully try to rearm itself),
batadv_tp_stop_all() skips its batadv_tp_vars_put(), and
batadv_tp_receiver_shutdown() fails to put its own reference as well.
Fix this by introducing a new atomic variable receiving that is set to 1
when the receiver is initialized and cleared atomically with atomic_xchg()
by whichever side claims it first. Only the side that observes the
transition from 1 to 0 is responsible for releasing the tp_vars timer
reference, eliminating the uncertainty. |
| Windows Recovery Environment Agent Elevation of Privilege Vulnerability |
| Improper access control in Extensible Storage Engine (ESENT) allows an authorized attacker to elevate privileges locally. |
| Improper authorization in Windows Installer allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: ti: k3-udma-glue: Fix of_k3_udma_glue_parse_chn_by_id()
The of_k3_udma_glue_parse_chn_by_id() helper function erroneously
invokes "of_node_put()" on the "udmax_np" device-node passed to it,
without having incremented its reference count at any point. Fix it. |
| In the Linux kernel, the following vulnerability has been resolved:
dmaengine: xilinx: xdma: Fix data synchronisation in xdma_channel_isr()
Requests the vchan lock before using xdma->stop_request. |
| In the Linux kernel, the following vulnerability has been resolved:
ax25: Fix refcount imbalance on inbound connections
When releasing a socket in ax25_release(), we call netdev_put() to
decrease the refcount on the associated ax.25 device. However, the
execution path for accepting an incoming connection never calls
netdev_hold(). This imbalance leads to refcount errors, and ultimately
to kernel crashes.
A typical call trace for the above situation will start with one of the
following errors:
refcount_t: decrement hit 0; leaking memory.
refcount_t: underflow; use-after-free.
And will then have a trace like:
Call Trace:
<TASK>
? show_regs+0x64/0x70
? __warn+0x83/0x120
? refcount_warn_saturate+0xb2/0x100
? report_bug+0x158/0x190
? prb_read_valid+0x20/0x30
? handle_bug+0x3e/0x70
? exc_invalid_op+0x1c/0x70
? asm_exc_invalid_op+0x1f/0x30
? refcount_warn_saturate+0xb2/0x100
? refcount_warn_saturate+0xb2/0x100
ax25_release+0x2ad/0x360
__sock_release+0x35/0xa0
sock_close+0x19/0x20
[...]
On reboot (or any attempt to remove the interface), the kernel gets
stuck in an infinite loop:
unregister_netdevice: waiting for ax0 to become free. Usage count = 0
This patch corrects these issues by ensuring that we call netdev_hold()
and ax25_dev_hold() for new connections in ax25_accept(). This makes the
logic leading to ax25_accept() match the logic for ax25_bind(): in both
cases we increment the refcount, which is ultimately decremented in
ax25_release(). |
| In the Linux kernel, the following vulnerability has been resolved:
net: macsec: Fix offload support for NETDEV_UNREGISTER event
Current macsec netdev notify handler handles NETDEV_UNREGISTER event by
releasing relevant SW resources only, this causes resources leak in case
of macsec HW offload, as the underlay driver was not notified to clean
it's macsec offload resources.
Fix by calling the underlay driver to clean it's relevant resources
by moving offload handling from macsec_dellink() to macsec_common_dellink()
when handling NETDEV_UNREGISTER event. |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: arm64: Fix host stage-2 PGD refcount
The KVM page-table library refcounts the pages of concatenated stage-2
PGDs individually. However, when running KVM in protected mode, the
host's stage-2 PGD is currently managed by EL2 as a single high-order
compound page, which can cause the refcount of the tail pages to reach 0
when they shouldn't, hence corrupting the page-table.
Fix this by introducing a new hyp_split_page() helper in the EL2 page
allocator (matching the kernel's split_page() function), and make use of
it from host_s2_zalloc_pages_exact(). |
| In the Linux kernel, the following vulnerability has been resolved:
drm/msm/a3xx: fix error handling in a3xx_gpu_init()
These error paths returned 1 on failure, instead of a negative error
code. This would lead to an Oops in the caller. A second problem is
that the check for "if (ret != -ENODATA)" did not work because "ret" was
set to 1. |
| In the Linux kernel, the following vulnerability has been resolved:
hfsplus: prevent corruption in shrinking truncate
I believe there are some issues introduced by commit 31651c607151
("hfsplus: avoid deadlock on file truncation")
HFS+ has extent records which always contains 8 extents. In case the
first extent record in catalog file gets full, new ones are allocated from
extents overflow file.
In case shrinking truncate happens to middle of an extent record which
locates in extents overflow file, the logic in hfsplus_file_truncate() was
changed so that call to hfs_brec_remove() is not guarded any more.
Right action would be just freeing the extents that exceed the new size
inside extent record by calling hfsplus_free_extents(), and then check if
the whole extent record should be removed. However since the guard
(blk_cnt > start) is now after the call to hfs_brec_remove(), this has
unfortunate effect that the last matching extent record is removed
unconditionally.
To reproduce this issue, create a file which has at least 10 extents, and
then perform shrinking truncate into middle of the last extent record, so
that the number of remaining extents is not under or divisible by 8. This
causes the last extent record (8 extents) to be removed totally instead of
truncating into middle of it. Thus this causes corruption, and lost data.
Fix for this is simply checking if the new truncated end is below the
start of this extent record, making it safe to remove the full extent
record. However call to hfs_brec_remove() can't be moved to it's previous
place since we're dropping ->tree_lock and it can cause a race condition
and the cached info being invalidated possibly corrupting the node data.
Another issue is related to this one. When entering into the block
(blk_cnt > start) we are not holding the ->tree_lock. We break out from
the loop not holding the lock, but hfs_find_exit() does unlock it. Not
sure if it's possible for someone else to take the lock under our feet,
but it can cause hard to debug errors and premature unlocking. Even if
there's no real risk of it, the locking should still always be kept in
balance. Thus taking the lock now just before the check. |
| A malicious actor with access to the network and low privileges and under certain conditions could exploit an Improper Access Control vulnerability found in UniFi OS with UniFi Protect Application to escalate privileges on the host device. |
| Improper access control in Microsoft 365 Copilot for iOS allows an unauthorized attacker to elevate privileges over a network. |
| Sangoma Technologies FreePBX before cdr 15.0.18, 16.0.40, 15.0.16, and 16.0.17 was discovered to contain an access control issue via a modified parameter value, e.g., changing extension=self to extension=101. |
| In the Linux kernel, the following vulnerability has been resolved:
vsock/virtio: fix MSG_ZEROCOPY pinned-pages accounting
virtio_transport_init_zcopy_skb() uses iter->count as the size argument
for msg_zerocopy_realloc(), which in turn passes it to
mm_account_pinned_pages() for RLIMIT_MEMLOCK accounting. However, this
function is called after virtio_transport_fill_skb() has already consumed
the iterator via __zerocopy_sg_from_iter(), so on the last skb, iter->count
will be 0, skipping the RLIMIT_MEMLOCK enforcement.
Pass pkt_len (the total bytes being sent) as an explicit parameter to
virtio_transport_init_zcopy_skb() instead of reading the already-consumed
iter->count.
This matches TCP and UDP, which both call msg_zerocopy_realloc() with
the original message size. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Fix global performance monitor reference counting
In the SET_GLOBAL ioctl, v3d_perfmon_find() bumps the reference count on
the perfmon it returns, but v3d_perfmon_set_global_ioctl() and
v3d_perfmon_delete() fail to release that reference on several paths:
1. v3d_perfmon_set_global_ioctl() leaks the reference on its error
paths.
2. CLEAR_GLOBAL leaks both the find reference and the reference
previously stashed in v3d->global_perfmon by the SET_GLOBAL ioctl
that configured it.
3. Destroying a perfmon that is the current global perfmon leaks the
reference stashed by the SET_GLOBAL ioctl.
Release each of these references explicitly. |
