| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath12k: fix memory leak in ath12k_wifi7_dp_rx_h_verify_tkip_mic()
In ath12k_wifi7_dp_rx_h_verify_tkip_mic(), the call to
ath12k_dp_rx_check_nwifi_hdr_len_valid() may return false when the
NWIFI header length is invalid, causing the function to abort early with
-EINVAL.
When this happens, the error propagates to
ath12k_wifi7_dp_rx_h_defrag(), which clears first_frag by setting it
to NULL. As a result, the corresponding MSDU is no longer referenced
by the defragmentation path and is never freed.
This leads to a memory leak for the affected MSDU on this error path.
Proper cleanup is required to ensure the MSDU is released when header
validation fails during TKIP MIC verification.
Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.1.c5-00302-QCAHMTSWPL_V1.0_V2.0_SILICONZ-1.115823.3 |
| In the Linux kernel, the following vulnerability has been resolved:
iomap: release pages on atomic dio size mismatch
If bio_iov_iter_get_pages() or the bounce helper succeeds but builds a
short bio, the REQ_ATOMIC size check rejects it before submission. The
old error path only dropped the bio reference, leaving any pages already
attached to the bio unreleased.
Release or unbounce the pages before falling through to out_put_bio on
this error path.
This bug was reported by sashiko:
https://sashiko.dev/#/patchset/20260608073134.95964-1-changfengnan%40bytedance.com |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: fix metabuf leak in inode xattr initialization
commit bb88e8da0025 ("erofs: use meta buffers for xattr operations")
converted xattr operations to use on-stack erofs_buf instances.
erofs_init_inode_xattrs() uses such a metabuf while reading the inline
xattr header and shared xattr id array.
Some error paths after erofs_read_metabuf() leave through out_unlock
without dropping the metabuf, so the folio reference can leak.
Consolidate the cleanup at out_unlock. erofs_put_metabuf() is a
no-op if no folio has been acquired, and this keeps all paths after
taking EROFS_I_BL_XATTR_BIT covered by a single cleanup site. |
| In the Linux kernel, the following vulnerability has been resolved:
nvme-pci: fix dma_vecs leak on p2p memory
We don't unmap P2P memory, so we don't need to track it. The dma_vec
allocation was getting leaked on the completion. |
| In the Linux kernel, the following vulnerability has been resolved:
nvme-pci: fix dma mapping leak on data setup error
We're leaking the initial DMA mapping during iteration if we fail to
allocate the tracking descriptor for both PRP and SGL. Unmap the
iterator directly; we can't use the existing unmap helper because it
depends on the tracking descriptor being successfully allocated, so a
new one for an in-use iterator is provided.
The mappings were also leaking when the driver detects an invalid
bio_vec when mapping PRPs, so fix that too. |
| In the Linux kernel, the following vulnerability has been resolved:
ACPI: button: Fix ACPI GPE handler leak during removal
Commit a7e23ec17fee ("ACPI: button: Install notifier for system events
as well") changed the ACPI notify handler type for ACPI buttons to
ACPI_ALL_NOTIFY, but it forgot to update acpi_button_remove() to reflect
that change. This leads to leaking the notify handler past driver
removal, which may cause a kernel crash to occur if ACPI notify on
the given device is triggered after removing the driver, and causes a
subsequent probe of the given device with the same driver to fail.
Address this by updating the acpi_remove_notify_handler() call in
acpi_button_remove() as appropriate. |
| In the Linux kernel, the following vulnerability has been resolved:
gfs2: fix memory leaks in gfs2_fill_super error path
Fix two memory leaks in the gfs2_fill_super() error handling path when
transitioning a filesystem to read-write mode fails.
First leak: kthread objects (thread_struct, task_struct, etc.)
When gfs2_freeze_lock_shared() fails after init_threads() succeeds, the
created kernel threads (logd and quotad) are never destroyed. This
occurs because the fail_per_node label doesn't call
gfs2_destroy_threads().
Second leak: quota bitmap buffer (8192 bytes)
When gfs2_make_fs_rw() fails after gfs2_quota_init() succeeds but
before other operations complete, the allocated quota bitmap is never
freed.
The fix moves thread cleanup to the fail_per_node label to handle all
error paths uniformly. gfs2_destroy_threads() is safe to call
unconditionally as it checks for NULL pointers. Quota cleanup is added
in gfs2_make_fs_rw() to properly handle the withdrawal case where
quota initialization succeeds but the filesystem is then withdrawn.
Thread leak backtrace (gfs2_freeze_lock_shared failure):
unreferenced object 0xffff88801d7bca80 (size 4480):
copy_process+0x3a1/0x4670 kernel/fork.c:2422
kernel_clone+0xf3/0x6e0 kernel/fork.c:2779
kthread_create_on_node+0x100/0x150 kernel/kthread.c:478
init_threads+0xab/0x350 fs/gfs2/ops_fstype.c:611
gfs2_fill_super+0xe5c/0x1240 fs/gfs2/ops_fstype.c:1265
Quota leak backtrace (gfs2_make_fs_rw failure):
unreferenced object 0xffff88812de7c000 (size 8192):
gfs2_quota_init+0xe5/0x820 fs/gfs2/quota.c:1409
gfs2_make_fs_rw+0x7a/0xe0 fs/gfs2/super.c:149
gfs2_fill_super+0xfbb/0x1240 fs/gfs2/ops_fstype.c:1275 |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_sync: hci_cmd_sync_queue_once() return -EEXIST if exists
hci_cmd_sync_queue_once() needs to indicate whether a queue item was
added, so caller can know if callbacks are called, so it can avoid
leaking resources.
Change the function to return -EEXIST if queue item already exists.
Modify all callsites to handle that. |
| ImageMagick before 6.9.13-57 and 7.x before 7.1.2-32 contains a memory leak in the SVG encoder (WriteSVGImage) that fails to release allocated memory when handling crafted images. Attackers can supply crafted image files that are processed by the SVG encoder to leak memory and cause a denial of service through resource consumption. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_ct: fix missing expect put in obj eval
nft_ct_expect_obj_eval() allocates an expectation and may call
nf_ct_expect_related(), but never drops its local reference.
Add nf_ct_expect_put(exp) before return to balance allocation. |
| In the Linux kernel, the following vulnerability has been resolved:
tun: free page on build_skb failure in tun_xdp_one()
When build_skb() fails in tun_xdp_one(), the function sets ret to
-ENOMEM and jumps to the out label, which returns without freeing the
page that vhost_net_build_xdp() allocated for the frame. As with the
short-frame rejection path, tun_sendmsg() discards the per-buffer error
and still returns total_len, so vhost_tx_batch() takes the success path
and never frees the page. Each build_skb() failure in a batch leaks one
page-frag chunk.
Free the page before taking the error path, matching the put_page() the
other error exits of tun_xdp_one() already perform. |
| In the Linux kernel, the following vulnerability has been resolved:
tap: free page on error paths in tap_get_user_xdp()
tap_get_user_xdp() rejects a frame shorter than ETH_HLEN with -EINVAL,
and returns -ENOMEM when build_skb() fails. Both paths jump to the err
label without freeing the page that vhost_net_build_xdp() allocated for
the frame. tap_sendmsg() discards the per-buffer return value and always
returns 0, so vhost_tx_batch() takes the success path and never frees
the page; each rejected frame in a batch leaks one page-frag chunk.
Free the page on both error paths, before the skb is built. This is the
tap counterpart of the same leak in tun_xdp_one(). |
| In the Linux kernel, the following vulnerability has been resolved:
ipv6: xfrm6: release dst on error in xfrm6_rcv_encap()
xfrm6_rcv_encap() performs an IPv6 route lookup when the skb does not
already have a dst attached. ip6_route_input_lookup() returns a
referenced dst entry even when the lookup resolves to an error route.
If dst->error is set, xfrm6_rcv_encap() drops the skb without attaching
the dst to the skb and without releasing the reference returned by the
lookup. Repeated packets hitting this path therefore leak dst entries.
Release the dst before jumping to the drop path. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: fix resource leaks on device setup failure
Make sure to call controller cleanup() if spi_setup() fails while
registering a device to avoid leaking any resources allocated by
setup(). |
| In the Linux kernel, the following vulnerability has been resolved:
ipmi:ssif: Clean up kthread on errors
If an error occurs after the ssif kthread is created, but before the
main IPMI code starts the ssif interface, the ssif kthread will not
be stopped.
So make sure the kthread is stopped on an error condition if it is
running. |
| In the Linux kernel, the following vulnerability has been resolved:
net: qrtr: ns: Free the node during ctrl_cmd_bye()
A node sends the BYE packet when it is about to go down. So the nameserver
should advertise the removal of the node to all remote and local observers
and free the node finally. But currently, the nameserver doesn't free the
node memory even after processing the BYE packet. This causes the node
memory to leak.
Hence, remove the node from Xarray list and free the node memory during
both success and failure case of ctrl_cmd_bye(). |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: sd: fix missing put_disk() when device_add(&disk_dev) fails
If device_add(&sdkp->disk_dev) fails, put_device() runs
scsi_disk_release(), which frees the scsi_disk but leaves the gendisk
referenced. The device_add_disk() error path in sd_probe() calls
put_disk(gd); call put_disk(gd) here to mirror that cleanup. |
| The Bluetooth Mesh Access layer delayable-message machinery in subsys/bluetooth/mesh/delayable_msg.c manages a static pool of CONFIG_BT_MESH_ACCESS_DELAYABLE_MSG_COUNT message contexts (default 4) threaded onto a free_ctx or busy_ctx list. release_delayable_msg_ctx() returned a context to free_ctx only when sys_slist_find_and_remove() found it on busy_ctx. The chunk-exhaustion error path in bt_mesh_delayable_msg_manage() releases a context that was already popped off free_ctx but not yet inserted on busy_ctx, so the context was appended to neither list and was permanently lost from the pool. Because bt_mesh_delayable_msg_init() runs only once from bt_mesh_init(), and node reset/suspend only drain busy_ctx, the loss survives unprovision, re-provision and suspend/resume — it is cleared only by a reboot.
The error path is reached when the chunk pool (CONFIG_BT_MESH_ACCESS_DELAYABLE_MSG_CHUNK_COUNT, default 40 chunks) is short of the chunks a new delayed message needs and the oldest pending message cannot be flushed because bt_mesh_access_send() returns -EBUSY or -ENOBUFS (all segmented-TX contexts busy, or advertising/segment buffers exhausted). A peer that is provisioned into the mesh network — holding a valid NetKey plus an AppKey or DevKey bound to a server model — can drive both conditions by flooding the victim with requests that elicit segmented responses while withholding the Segment Acknowledgment, which keeps the transmit contexts occupied while queued responses hold the chunk pool. Each further request that arrives in that window leaks one context.
Once the pool is drained, bt_mesh_delayable_msg_manage() returns -ENOMEM for every subsequent send and bt_mesh_model_send() propagates that error with no fallback to an immediate transmit. Since CONFIG_BT_MESH_ACCESS_DELAYABLE_MSG and CONFIG_BT_MESH_ACCESS_DELAYABLE_MSG_CTX_ENABLED are both enabled by default, ctx->rnd_delay is set for every received access message, so all replies from Configuration Server, Health Server and application server models are silently dropped. The node keeps receiving and processing traffic but never answers, a persistent denial of service until the device is restarted. There is no memory corruption, information disclosure or integrity impact; releases before the fix compute the chunk count from the transmit buffer capacity rather than its payload length, making chunk-pool starvation — and therefore the leak — considerably easier to provoke. |
| xmlParseBalancedChunkMemoryRecover in parser.c in libxml2 before 2.9.10 has a memory leak related to newDoc->oldNs. |
| Libreswan in FIPS mode has a vulnerability where badly formed received certificates are rejected, but not deleted from the NSS cache. As a result, any real certificates with the same serial number are rejected as well. This can be abused to lock out legitimate peers from connecting. The add_decoded_cert() function missed a call to CERT_DestroyCertificate() due to an incorrect fix for CVE-2026-14957. Sending bogus certificates with new serial numbers could prevent the real certificates with those serial numbers from connecting until the service has restarted. |