| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Missing SNI/ALPN binding on stateful (session-ID) resumption, which previously skipped the binding check performed for ticket-based resumption. A cached session could be resumed under a different SNI/ALPN than originally negotiated and, where client-authentication policy differs across virtual hosts, carry the cached peer-authentication state into a context it was not established for. Resumption now verifies the SNI/ALPN binding for all paths and declines (falling back to a full handshake) on mismatch. |
| TLS 1.3 post-handshake authentication (PHA) issue where a server could accept a client's Finished message without the client having sent a Certificate and CertificateVerify. The post-handshake-auth exemption that allows an empty/absent peer certificate was only intended for the initial handshake, but it was also being applied while a post-handshake CertificateRequest was still outstanding. The check is now scoped to the initial handshake only: on the server, once a post-handshake CertificateRequest has been sent (certReqCtx is set), a peer certificate and a valid CertificateVerify are required again before the Finished is accepted, with empty-certificate handling following the configured verify mode (FAIL_IF_NO_PEER_CERT) just as during first-handshake client authentication. Only affects TLS 1.3 servers built with post-handshake authentication support (WOLFSSL_POST_HANDSHAKE_AUTH / --enable-postauth, included in --enable-all) that enable WOLFSSL_VERIFY_POST_HANDSHAKE and request a client certificate after the handshake via wolfSSL_request_certificate(). Clients, and servers that do not use post-handshake authentication, are unaffected. |
| When HAVE_ENCRYPT_THEN_MAC is configured, the implementation could fall back to MAC-then-Encrypt rather than enforcing Encrypt-then-MAC. |
| Out-of-bounds write in SetSuitesHashSigAlgo when processing an oversized signature algorithms list, allowing a write past the bounds of the destination buffer. |
| PKCS#12 MAC verification uses an attacker-controlled comparison length, weakening the integrity check on the MAC and allowing a mismatched MAC to be accepted. The PKCS#12 verify path compared the locally computed HMAC against the MAC parsed from the PKCS#12 structure using a length taken directly from the attacker-supplied input, without first verifying that it equals the length of the digest actually produced by the configured algorithm. A truncated or zero-length stored MAC could therefore be accepted, defeating the integrity protection of the MAC. |
| The ML-KEM ARM64 NEON ciphertext comparison only compares half of the input, breaking the Fujisaki-Okamoto transform's implicit rejection and weakening IND-CCA2 security on that code path. The constant-time comparison effectively ignored part of the re-encrypted ciphertext, so a decapsulating party could fail to detect a manipulated ciphertext and proceed without the standard's required implicit rejection. |
| Heap buffer overread in wc_PKCS7_DecodeEnvelopedData when parsing crafted PKCS7 EnvelopedData. This could theoretically be triggered by attacker-supplied data delivered via S/MIME or CMS. |
| Bleichenbacher padding oracle in PKCS#7 KTRI decryption. When decrypting PKCS#7 EnvelopedData using RSA PKCS#1 v1.5 key transport, wolfSSL returned distinguishable error codes depending on whether RSA padding validation failed versus whether the decrypted content was malformed. An attacker able to submit crafted EnvelopedData messages and observe error responses could use this as a padding oracle to incrementally recover the encrypted Content Encryption Key (CEK). The fix generates a deterministic pseudo-random fake CEK on padding failure (via HMAC-SHA256) and proceeds with decryption identically, using constant-time operations throughout, so that all failure paths produce the same error regardless of padding validity. |
| Partial-chain certificate verification may accept chains that terminate at a peer-supplied, untrusted intermediate certificate rather than a trusted anchor. An attacker could present a chain that ends at an intermediate they control and have it accepted as valid. This affects the OpenSSL compatibility certificate-path-building path (wolfSSL_X509_verify_cert / X509_STORE, OPENSSL_EXTRA) when the X509_V_FLAG_PARTIAL_CHAIN verify flag is enabled. |
| wolfSSL_PKCS7_verify() returning success for a degenerate (certs-only) PKCS#7 object that contains no signer. Such an object has empty signerInfos, so the underlying signed-data verification succeeds without authenticating any content. The compatibility-layer verify path now rejects the object when no signer signature has actually been verified, so a PKCS#7 carrying no valid signature is no longer reported as verified. This is enforced regardless of the PKCS7_NOVERIFY flag, which only suppresses signer certificate chain validation and was never intended to waive the requirement that a signature exist. Only affects OpenSSL compatibility builds that call the PKCS7_verify() compatibility API on potentially degenerate PKCS#7 bundles. |
| AES-GCM encryption/decryption with extremely large cumulative single message sizes (>64 GiB) were not properly rejected by the streaming APIs, allowing counter wrap, keystream reuse, and consequent plaintext recovery. |
| X.509 trust-chain bypass (path-depth exhaustion) in the OpenSSL compatibility certificate verifier (wolfSSL_X509_verify_cert()). This affects only builds with --enable-opensslextra whose application calls X509_verify_cert() with caller-supplied untrusted intermediates; for those users it is critical, otherwise the library is unaffected. Native wolfSSL TLS/DTLS usage is not impacted. X509_verify_cert() returned success based only on the last verified link rather than on reaching a trust anchor: when the supplied chain is deeper than the verifier's maximum path depth (default 100), path building runs out of depth while still walking untrusted intermediates and the chain is accepted even though it never reaches a configured trust anchor, allowing acceptance of an attacker-controlled certificate. The default TLS handshake (WOLFSSL_VERIFY_PEER) is not affected; only applications doing manual or deferred verification through this API are. |
| Missing hash/digest size and OID checks allow digests smaller than allowed when verifying ECDSA certificates, or smaller than is appropriate for the relevant key type, to be accepted by signature verification functions. This could lead to reduced security of ECDSA certificate-based authentication if the public CA key used is also known. This affects ECDSA/ECC verification when EdDSA or ML-DSA is also enabled. |
| In wolfSSL, ARIA-GCM cipher suites used in TLS 1.2 and DTLS 1.2 reuse an identical 12-byte GCM nonce for every application-data record. Because wc_AriaEncrypt is stateless and passes the caller-supplied IV verbatim to the MagicCrypto SDK with no internal counter, and because the explicit IV is zero-initialized at session setup and never incremented in non-FIPS builds. This vulnerability affects wolfSSL builds configured with --enable-aria and the proprietary MagicCrypto SDK (a non-default, opt-in configuration required for Korean regulatory deployments). AES-GCM is not affected because wc_AesGcmEncrypt_ex maintains an internal invocation counter independently of the call-site guard. |
| Heap buffer overflow in CertFromX509 via AuthorityKeyIdentifier size confusion. A heap buffer overflow occurs when converting an X.509 certificate internally due to incorrect size handling of the AuthorityKeyIdentifier extension. |
| URI nameConstraints from constrained intermediate CAs are parsed but not enforced during certificate chain verification in wolfcrypt/src/asn.c. A compromised or malicious sub-CA could issue leaf certificates with URI SAN entries that violate the nameConstraints of the issuing CA, and wolfSSL would accept them as valid. |
| Heap buffer overflow in DTLS 1.3 ACK message processing. A remote attacker can send a crafted DTLS 1.3 ACK message that triggers a heap buffer overflow. |
| A 1-byte stack buffer over-read was identified in the MatchDomainName function (src/internal.c) during wildcard hostname validation when the LEFT_MOST_WILDCARD_ONLY flag is active. If a wildcard * exhausts the entire hostname string, the function reads one byte past the buffer without a bounds check, which could cause a crash. |
| Integer underflow in wolfSSL packet sniffer <= 5.9.0 allows an attacker to cause a program crash in the AEAD decryption path by injecting a TLS record shorter than the explicit IV plus authentication tag into traffic inspected by ssl_DecodePacket. The underflow wraps a 16-bit length to a large value that is passed to AEAD decryption routines, causing a large out-of-bounds read and crash. An unauthenticated attacker can trigger this remotely via malformed TLS Application Data records. |
| A stack buffer overflow exists in wolfSSL's PKCS7 implementation in the wc_PKCS7_DecryptOri() function in wolfcrypt/src/pkcs7.c. When processing a CMS EnvelopedData message containing an OtherRecipientInfo (ORI) recipient, the function copies an ASN.1-parsed OID into a fixed 32-byte stack buffer (oriOID[MAX_OID_SZ]) via XMEMCPY without first validating that the parsed OID length does not exceed MAX_OID_SZ. A crafted CMS EnvelopedData message with an ORI recipient containing an OID longer than 32 bytes triggers a stack buffer overflow. Exploitation requires the library to be built with --enable-pkcs7 (disabled by default) and the application to have registered an ORI decrypt callback via wc_PKCS7_SetOriDecryptCb(). |
