| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Zephyr's OpenThread integration defined CONFIG_OPENTHREAD_JOINER_PSKD with default "J01NME" in modules/openthread/Kconfig.thread (previously subsys/net/l2/openthread/Kconfig, then subsys/net/l2/openthread/Kconfig.thread). J01NME is the example Joining Device Credential used throughout the public OpenThread and Thread commissioning documentation, including Zephyr's own samples/net/sockets/echo_client/README.rst, so it is not a secret. A firmware image built with CONFIG_OPENTHREAD_JOINER_AUTOSTART=y that never overrode the PSKd therefore shipped with a publicly known joining credential compiled in, with no build-time or run-time warning.
The PSKd is the only value that authenticates Thread commissioning: joiner and commissioner run a DTLS-PSK handshake keyed on it, after which the commissioner supplies the full operational dataset. In ot_configure_instance() (modules/openthread/openthread.c), a device with no stored dataset calls otJoinerStart() with the configured PSKd, and ot_joiner_start_handler() calls otThreadSetEnabled() on success. An unauthenticated attacker within 802.15.4 radio range of an uncommissioned device (factory-fresh, after a factory reset, or after a settings erase) can run any stock Thread commissioner registered with J01NME, complete the handshake, and hand the device an attacker-controlled operational dataset.
The device then joins and enables Thread on the attacker's mesh. The attacker becomes its router, seeing, dropping, injecting and spoofing all of the device's IPv6 traffic and impersonating the peers the application expects, while the device is cut off from the network it was meant to join and stays mis-provisioned until it is reset. Only application-layer security with independently provisioned credentials survives. Exposure is limited to builds that enable joiner autostart and leave the PSKd unset; the option is not enabled by default and no in-tree sample uses the vulnerable combination.
The fix removes the default from CONFIG_OPENTHREAD_JOINER_PSKD and adds a BUILD_ASSERT() in modules/openthread/openthread.c, active only under CONFIG_OPENTHREAD_JOINER_AUTOSTART, that fails the build unless a 6-to-32-character PSKd is configured. Products should provision a per-device PSKd from factory data and call otJoinerStart() from the application rather than relying on a credential compiled identically into every unit. |
| The system certificate authority (CA) store in Red Hat products, distributed via ca-certificates RPM packages, included multiple root CA certificates of authorities, which signed intermediate CA certificates with weak private keys issued by the eMudhra certificate authority. A man-in-the-middle attacker could use this flaw to issue certificates for arbitrary host names signed by the weak intermediate CA certificates, which would be considered trusted by a TLS/SSL client using system CA store and cause such clients to connect to malicious sites.
Due to inability to only distrust specific intermediate certificates in all clients using the system CA store, root CA certificates of authorities that signed weak intermediate CA certificates are being removed. |
| Improper link resolution before file access ('link following') in Windows Update allows an authorized attacker to elevate privileges locally. |
| Improper neutralization of special elements used in a command ('command injection') in Windows Update allows an authorized attacker to elevate privileges locally. |
| Untrusted search path in Windows Update allows an authorized attacker to elevate privileges locally. |
| Double free in Windows Kerberos allows an authorized attacker to elevate privileges locally. |
| Improper link resolution before file access ('link following') in Windows Backup Engine allows an authorized attacker to elevate privileges locally. |
| A security flaw has been discovered in Tenda F6 12.02.01.73. This impacts an unknown function of the component Web Management Interface. Performing a manipulation results in cross-site request forgery. The attack may be initiated remotely. The exploit has been released to the public and may be used for attacks. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/mm: Don't apply va_align to hugetlb mappings on AMD F15h
get_align_mask() returns huge_page_mask_align() for hugetlbfs, but get_align_bits()
adds va_align.bits regardless, so vm_unmapped_area() returns an address off the huge
page boundary and __unmap_hugepage_range() hits BUG_ON(start & ~huge_page_mask(h)) at
teardown.
This can be triggered on Carrizo and FX-8370E, both hstates.
Pass the file to get_align_bits() and skip the randomisation for hugetlbfs.
[ bp: Massage commit message. ] |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: hci_conn: Lock parent access during enhanced SCO setup
Bluetooth: hci_conn: Lock parent access during enhanced SCO setup
hci_enhanced_setup_sync() runs on the request workqueue without the
hci_dev_lock held by its caller when setup was queued. Its CVSD
capability check and find_next_esco_param() dereference conn->parent
while the receive workqueue can unlink and release that parent.
The following interleaving can cause a use-after-free:
hci_enhanced_setup_sync() hci_disconn_complete_evt()
load conn->parent
hci_dev_lock()
hci_conn_del(ACL parent)
unlink SCO child
drop link's parent reference
clear child->parent
release ACL parent
bt_link_release()
kfree(parent)
hci_dev_unlock()
read parent->features[0][3]
The reference held for the queued SCO child does not keep its ACL parent
alive after unlinking. Commit 42de40abe25d ("Bluetooth: hci_conn: fix the
SCO setup context lifetime") protects the child stored in the queued
context, but leaves these parent accesses unprotected.
With a 40 ms diagnostic delay after loading conn->parent, an instrumented
kernel based on fd179f8a05be, which already contains 42de40abe25d,
BUG: KASAN: slab-use-after-free in hci_enhanced_setup_sync+0xda5/0xdf0
Read of size 1 at addr ffff888102204047 by task kworker/u17:0/93
Call Trace:
hci_enhanced_setup_sync+0xda5/0xdf0
hci_cmd_sync_work+0x13c/0x290
process_one_work+0x6b4/0x10e0
Allocated by task 92:
__hci_conn_add+0x304/0x1df0
hci_connect_acl+0x349/0x3e0
hci_connect_sco+0x3b/0x9a0
sco_sock_connect+0x475/0xca0
Freed by task 94:
kfree+0x121/0x3c0
bt_link_release+0x79/0xa0
device_release+0xc8/0x240
kobject_put+0x14d/0x280
hci_conn_del+0x524/0xe30
hci_disconn_complete_evt+0x403/0x8c0
hci_event_packet+0x71b/0xb20
hci_rx_work+0x293/0x730
The accessed address is 71 bytes into the freed ACL parent, at its
features[0][3] byte; the queued SCO child is a different object. The
diagnostic preserves the loaded parent across the delay, matching the
unmodified compiled capability check, and does not change the parent
references or teardown path.
Hold hci_dev_lock() across the codec switch, including every call to
find_next_esco_param(), and release it on all selection errors. Keep
configure_datapath_sync() outside the critical section because it waits
for HCI events. Preserve parameter selection and existing return values. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: RFCOMM: Fix initial port reference race
For RFCOMM_RELEASE_ONHUP devices, rfcomm_tty_install() and
__rfcomm_release_dev() both use RFCOMM_TTY_OWNED to decide who drops the
initial tty_port reference. The release path tests the bit separately
from the install path setting it, so both can drop that reference.
The synchronous hangup does not prevent this race: port->tty is not
assigned until tty_port_open(), after installation. The following
interleaving is possible:
1. Install and release each obtain a reference with rfcomm_dev_get().
2. Release observes RFCOMM_TTY_OWNED clear.
3. Install sets RFCOMM_TTY_OWNED and drops the initial reference.
4. Release drops the same initial reference again.
5. TTY cleanup drops its reference and frees the device.
6. Release performs its final tty_port_put() on the freed port.
KASAN reported:
BUG: KASAN: slab-use-after-free in tty_port_put+0x22/0x190
Write of size 4 at addr ffff8881001d3d5c by task poc/92
Call Trace:
tty_port_put+0x22/0x190
rfcomm_dev_ioctl+0x1d4/0x1930
sock_do_ioctl+0x110/0x260
sock_ioctl+0x380/0x590
__x64_sys_ioctl+0x134/0x1c0
Allocated by task 88:
rfcomm_dev_ioctl+0x8f6/0x1930
sock_do_ioctl+0x110/0x260
sock_ioctl+0x380/0x590
__x64_sys_ioctl+0x134/0x1c0
Freed by task 65:
kfree+0x131/0x3c0
rfcomm_dev_destruct+0x23b/0x2f0
release_one_tty+0xc1/0x370
process_one_work+0x661/0x1090
Use test_and_set_bit() in both paths so that only the caller that changes
RFCOMM_TTY_OWNED from clear to set drops the initial reference. Each path
keeps its own lookup reference until release or TTY cleanup, preserving
the existing callback ordering and error handling. |
| In the Linux kernel, the following vulnerability has been resolved:
EDAC/altera: Drop __init from ECC setup paths for re-probe safety
Sashiko reports:
"Does suppressing sysfs unbinding fully prevent the execution of freed __init
memory? If altr_sysmgr_regmap_lookup_by_phandle() returns -EPROBE_DEFER, the
probe is deferred until after __init memory is freed."
The a10 EDAC .setup callbacks (sdmmc, ethernet, nand, dma, usb, qspi) and
their helpers (altr_init_a10_ecc_device_type, altr_init_a10_ecc_block) were
marked __init. These run from the probe path, which may execute after init
memory is freed -- e.g. a probe deferred via -EPROBE_DEFER that only succeeds
once a late/module dependency appears, or a manual unbind/rebind. Calling
__init code then dereferences freed memory. Remove __init so these functions
remain valid at runtime. |
| In the Linux kernel, the following vulnerability has been resolved:
tty: abort break signalling on hangup
The break ioctls can race with hangup and end up calling into a tty
driver for a device that is already gone or powered down.
Drivers must handle this race, but TCSBRK and TCSBRKP should still be
aborted to avoid calling back into the driver after a user-controlled
timeout (possibly even after the tty has been reopened).
Note that drivers should disable any break state on shutdown so just
return on hangup (calling break_ctl() again is racy and will most likely
fail for drivers handling the race). |
| In the Linux kernel, the following vulnerability has been resolved:
tty: port: fix tty_port_tty_vhangup() race
Drivers rely on tty_port_tty_vhangup() to synchronously hang up their
ports before tearing down resources as part of deregistration (e.g. on
physical disconnect).
If tty_port_tty_vhangup() races with another hangup it may however
return before the port has been shut down. This is in turn can lead to
use-after-free and NULL-pointer dereferences in racing ioctls (including
a synchronous hangup) and in processing of racing asynchronous hangups
(carrier loss).
Add the missing serialisation to tty_port_tty_vhangup() and
tty_port_hangup() so that the former does not return until the port has
been shut down also when there is a racing hangup.
Note that serial core does not use tty_port_hangup(), but it already
holds the port mutex when clearing port->tty and shutting down the port
in uart_hangup(). |
| In the Linux kernel, the following vulnerability has been resolved:
tty: vcc: hold port lock when clearing tty pointer in vcc_cleanup
vcc_cleanup() sets port->tty to NULL without holding port->lock, racing
with vcc_event() LDC callbacks that read port->tty under port->lock and
then use tty->port. This can cause a use-after-free when the callback
dereferences tty->port after cleanup has already destroyed and freed it. |
| Vulnerability in Oracle Essbase (component: Security). The supported version that is affected is 21.8.3.0.0. Easily exploitable vulnerability allows low privileged attacker with network access via HTTP to compromise Oracle Essbase. While the vulnerability is in Oracle Essbase, attacks may significantly impact additional products (scope change). Successful attacks of this vulnerability can result in unauthorized access to critical data or complete access to all Oracle Essbase accessible data. CVSS 3.1 Base Score 7.7 (Confidentiality impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:L/PR:L/UI:N/S:C/C:H/I:N/A:N). |
| Use after free in Windows Win32 Kernel Subsystem allows an authorized attacker to elevate privileges locally. |
| Use after free in Windows USB Print Driver allows an authorized attacker to elevate privileges locally. |
| Use after free in Windows Update allows an authorized attacker to elevate privileges locally. |
| Out-of-bounds read in Remote Desktop Display Driver allows an authorized attacker to disclose information locally. |
