| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The Cisco Optical Service Module (OSM) for the Catalyst 6500 and 7600 series running Cisco IOS 12.1(8)E through 12.1(13.4)E allows remote attackers to cause a denial of service (hang) via a malformed packet. |
| The TCL shell in Cisco IOS 12.2(14)S before 12.2(14)S16, 12.2(18)S before 12.2(18)S11, and certain other releases before 25 January 2006 does not perform Authentication, Authorization, and Accounting (AAA) command authorization checks, which may allow local users to execute IOS EXEC commands that were prohibited via the AAA configuration, aka Bug ID CSCeh73049. |
| Cisco IOS 12.0S, 12.2, and 12.3, with Open Shortest Path First (OSPF) enabled, allows remote attackers to cause a denial of service (device reload) via a malformed OSPF packet. |
| Cisco 6000, 6500, and 7600 series systems with Multilayer Switch Feature Card 2 (MSFC2) and a FlexWAN or OSM module allow local users to cause a denial of service (hang or reset) by sending a layer 2 frame packet that encapsulates a layer 3 packet, but has inconsistent length values with that packet. |
| Cisco IOS 12.2 through 12.4 before 20060920, as used by Cisco IAD2430, IAD2431, and IAD2432 Integrated Access Devices, the VG224 Analog Phone Gateway, and the MWR 1900 and 1941 Mobile Wireless Edge Routers, is incorrectly identified as supporting DOCSIS, which allows remote attackers to gain read-write access via a hard-coded cable-docsis community string and read or modify arbitrary SNMP variables. |
| Cisco IOS 12.0 to 12.4 might allow remote attackers to execute arbitrary code via a heap-based buffer overflow in system timers. NOTE: this issue does not correspond to a specific vulnerability, rather a general weakness that only increases the feasibility of exploitation of any vulnerabilities that might exist. Such design-level weaknesses normally are not included in CVE, so perhaps this issue should be REJECTed. |
| Cisco IOS 12.2 and earlier generates a "% Login invalid" message instead of prompting for a password when an invalid username is provided, which allows remote attackers to identify valid usernames on the system and conduct brute force password guessing, as reported for the Aironet Bridge. |
| A vulnerability in the access control list (ACL) programming of Cisco IOS XE Software for Cisco Catalyst 9500X and 9600X Series Switches could allow an unauthenticated, remote attacker to bypass a configured ACL on an affected device.
This vulnerability is due to the flooding of traffic from an unlearned MAC address on a switch virtual interface (SVI) that has an egress ACL applied. An attacker could exploit this vulnerability by causing the VLAN to flush its MAC address table. This condition can also occur if the MAC address table is full. A successful exploit could allow the attacker to bypass an egress ACL on an affected device. |
| A vulnerability in the Cisco Industrial Ethernet Switch Device Manager (DM) of Cisco IOS Software could allow an authenticated, remote attacker to elevate privileges.
This vulnerability is due to insufficient validation of authorizations for authenticated users. An attacker could exploit this vulnerability by sending a crafted HTTP request to an affected device. A successful exploit could allow the attacker to elevate privileges to privilege level 15.
To exploit this vulnerability, the attacker must have valid credentials for a user account with privilege level 5 or higher. Read-only DM users are assigned privilege level 5. |
| A vulnerability in the Web Authentication feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to conduct a reflected cross-site scripting attack (XSS) on an affected device.
This vulnerability is due to improper sanitization of user-supplied input. An attacker could exploit this vulnerability by persuading a user to click a malicious link. A successful exploit could allow the attacker to execute a reflected XSS attack and steal user cookies from the affected device. |
| A vulnerability in the implementation of the TACACS+ protocol in Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to view sensitive data or bypass authentication.
This vulnerability exists because the system does not properly check whether the required TACACS+ shared secret is configured. A machine-in-the-middle attacker could exploit this vulnerability by intercepting and reading unencrypted TACACS+ messages or impersonating the TACACS+ server and falsely accepting arbitrary authentication requests. A successful exploit could allow the attacker to view sensitive information in a TACACS+ message or bypass authentication and gain access to the affected device. |
| A vulnerability in Cisco IOS XE Software could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to an affected device to execute persistent code at boot time and break the chain of trust. This vulnerability is due to improper validation of software packages. An attacker could exploit this vulnerability by placing a crafted file into a specific location on an affected device. A successful exploit could allow the attacker to execute persistent code on the underlying operating system. Because this vulnerability allows an attacker to bypass a major security feature of a device, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High. |
| A vulnerability in the handling of certain Ethernet frames in Cisco IOS XE Software for Catalyst 9000 Series Switches could allow an unauthenticated, adjacent attacker to cause an egress port to become blocked and drop all outbound traffic.
This vulnerability is due to improper handling of crafted Ethernet frames. An attacker could exploit this vulnerability by sending crafted Ethernet frames through an affected switch. A successful exploit could allow the attacker to cause the egress port to which the crafted frame is forwarded to start dropping all frames, resulting in a denial of service (DoS) condition. |
| A vulnerability in the CLI of Cisco IOS Software and Cisco IOS XE Software could allow an authenticated, local attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to a buffer overflow. An attacker with a low-privileged account could exploit this vulnerability by using crafted commands at the CLI prompt. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. |
| A vulnerability in the Address Resolution Protocol (ARP) implementation of Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to trigger a broadcast storm, leading to a denial of service (DoS) condition on an affected device.
This vulnerability is due to how Cisco IOS XR Software processes a high, sustained rate of ARP traffic hitting the management interface. Under certain conditions, an attacker could exploit this vulnerability by sending an excessive amount of traffic to the management interface of an affected device, overwhelming its ARP processing capabilities. A successful exploit could result in degraded device performance, loss of management connectivity, and complete unresponsiveness of the system, leading to a DoS condition. |
| A vulnerability in the implementation of the CLI on a device that is running ConfD could allow an authenticated, local attacker to perform a command injection attack.
The vulnerability is due to insufficient validation of a process argument on an affected device. An attacker could exploit this vulnerability by injecting commands during the execution of this process. A successful exploit could allow the attacker to execute arbitrary commands on the underlying operating system with the privilege level of ConfD, which is commonly root. |
| A vulnerability in the Layer 2 Ethernet services of Cisco IOS XR Software could allow an unauthenticated, adjacent attacker to cause the line card network processor to reset, resulting in a denial of service (DoS) condition.
This vulnerability is due to the incorrect handling of specific Ethernet frames that are received on line cards that have the Layer 2 services feature enabled. An attacker could exploit this vulnerability by sending specific Ethernet frames through an affected device. A successful exploit could allow the attacker to cause the ingress interface network processor to reset, resulting in a loss of traffic over the interfaces that are supported by the network processor. Multiple resets of the network processor would cause the line card to reset, resulting in a DoS condition. |
| A vulnerability in the IKEv2 feature of Cisco IOS Software, IOS XE Software, Secure Firewall ASA Software, and Secure FTD Software could allow an unauthenticated, remote attacker to cause the device to reload, resulting in a DoS condition.
This vulnerability is due to the improper processing of IKEv2 packets. An attacker could exploit this vulnerability by sending crafted IKEv2 packets to an affected device. A successful exploit could allow the attacker to cause an infinite loop that exhausts resources and could cause the device to reload. |
| A vulnerability in the access control list (ACL) processing on MPLS interfaces in the ingress direction of Cisco IOS XR Software could allow an unauthenticated, remote attacker to bypass a configured ACL.
This vulnerability is due to improper assignment of lookup keys to internal interface contexts. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to access resources behind the affected device that were supposed to be protected by a configured ACL. |
| A vulnerability in the Day One setup process of Cisco IOS XE Software for Catalyst 9800 Series Wireless Controllers for Cloud (9800-CL) could allow an unauthenticated, remote attacker to access the public-key infrastructure (PKI) server that is running on an affected device.
This vulnerability is due to incomplete cleanup upon completion of the Day One setup process. An attacker could exploit this vulnerability by sending Simple Certificate Enrollment Protocol (SCEP) requests to an affected device. A successful exploit could allow the attacker to request a certificate from the virtual wireless controller and then use the acquired certificate to join an attacker-controlled device to the virtual wireless controller. |
