| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: ebtables: module names must be null-terminated
We need to explicitly check the length, else we may pass non-null
terminated string to request_module(). |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: L2CAP: cancel pending_rx_work before taking conn->lock
l2cap_conn_del() takes conn->lock and then calls cancel_work_sync() for
pending_rx_work. process_pending_rx() takes the same mutex, so teardown
can deadlock against the worker it is flushing.
This issue was found by our static analysis tool and then manually
reviewed against the current tree.
The grounded PoC kept the l2cap_conn_ready() -> queue_work(...,
&conn->pending_rx_work) submit path, the l2cap_conn_del() ->
cancel_work_sync(&conn->pending_rx_work) teardown path, and the
process_pending_rx() -> mutex_lock(&conn->lock) worker edge. Lockdep
WARNING: possible circular locking dependency detected
process_pending_rx+0x21/0x2a [vuln_msv]
l2cap_conn_del.constprop.0+0x3f/0x4e [vuln_msv]
*** DEADLOCK ***
Cancel pending_rx_work before taking conn->lock, matching the existing
lock-before-drain ordering used for the two delayed works in the same
teardown path. The pending_rx queue is still purged after the work has
been cancelled and conn->lock has been acquired. |
| In the Linux kernel, the following vulnerability has been resolved:
net: bcmgenet: keep RBUF EEE/PM disabled
Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX
path on GENET hardware once MAC EEE becomes active. RX traffic stops
flowing while the link stays up and the usual descriptor/RX error
counters remain quiet. In that state the MAC still accepts frames
(rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to
DMA, so rx_packets is no longer incremented at the netdev level. On
some boards the corruption ends up as a paging fault in
skb_release_data via bcmgenet_rx_poll on an LPI exit.
Reproduced on Pi 4B (BCM2711 + BCM54213PE) and confirmed by Florian
Fainelli on an internal Broadcom 4908-family board with the same crash
signature. RBUF_PM_EN is not publicly documented.
This shows up more often now that phy_support_eee() enables EEE by
default, but it also affects older kernels as soon as TX LPI is
turned on via ethtool, so it is not specific to recent changes.
Always clear RBUF_EEE_EN | RBUF_PM_EN in bcmgenet_eee_enable_set so
the bits stay off across resets. UMAC and TBUF setup is left alone so
TX-side EEE keeps working. |
| In the Linux kernel, the following vulnerability has been resolved:
l2tp: pppol2tp: hold reference to session in pppol2tp_ioctl()
pppol2tp_ioctl() read sock->sk->sk_user_data directly without any
locks or reference counting. If a controllable sleep was induced during
copy_from_user() (e.g. via a userfaultfd page fault sleep), a concurrent
socket close could trigger pppol2tp_session_close() asynchronously. This
frees the l2tp_session structure via the l2tp_session_del_work workqueue.
Upon resuming, the ioctl thread dereferences the stale session pointer,
resulting in a Use-After-Free (UAF).
Fix this by securely fetching the session reference using the RCU-safe,
refcounted helper pppol2tp_sock_to_session(sk) on entry. This locks the
session's refcount across the sleep. We structured the function to exit
via standard err breaks, guaranteeing that l2tp_session_put() is cleanly
called on all return paths to drop the reference.
To preserve existing behavior we validate the session and its magic
signature only for the specific L2TP commands that require it. This
ensures that generic/unknown ioctls called on an unconnected socket
still return -ENOIOCTLCMD and correctly fall back to generic handlers
(e.g. in sock_do_ioctl()). |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: remove xfs_attr_leaf_hasname
The calling convention of xfs_attr_leaf_hasname() is problematic, because
it returns a NULL buffer when xfs_attr3_leaf_read fails, a valid buffer
when xfs_attr3_leaf_lookup_int returns -ENOATTR or -EEXIST, and a
non-NULL buffer pointer for an already released buffer when
xfs_attr3_leaf_lookup_int fails with other error values.
Fix this by simply open coding xfs_attr_leaf_hasname in the callers, so
that the buffer release code is done by each caller of
xfs_attr3_leaf_read. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/msm/adreno: Fix a reference leak in a6xx_gpu_init()
In a6xx_gpu_init(), node is obtained via of_parse_phandle().
While there was a manual of_node_put() at the end of the
common path, several early error returns would bypass this call,
resulting in a reference leak.
Fix this by using the __free(device_node) cleanup handler to
release the reference when the variable goes out of scope.
Patchwork: https://patchwork.freedesktop.org/patch/700661/ |
| In the Linux kernel, the following vulnerability has been resolved:
mshv: Fix error handling in mshv_region_pin
The current error handling has two issues:
First, pin_user_pages_fast() can return a short pin count (less than
requested but greater than zero) when it cannot pin all requested pages.
This is treated as success, leading to partially pinned regions being
used, which causes memory corruption.
Second, when an error occurs mid-loop, already pinned pages from the
current batch are not properly accounted for before calling
mshv_region_invalidate_pages(), causing a page reference leak.
Treat short pins as errors and fix partial batch accounting before
cleanup. |
| In the Linux kernel, the following vulnerability has been resolved:
posix-cpu-timers: Fix pid refcount leak in do_cpu_nanosleep() error path
In do_cpu_nanosleep(), posix_cpu_timer_create() takes a pid reference
via get_pid() and stores it in timer.it.cpu.pid. If the subsequent
posix_cpu_timer_set() call fails, the function returns immediately
without calling posix_cpu_timer_del() to release the pid reference,
causing a leak.
Fix it by calling posix_cpu_timer_del() before the unlock-and-return
on the error path, consistent with the other exit paths in the same
function. |
| In the Linux kernel, the following vulnerability has been resolved:
vsock/virtio: fix accept queue count leak on transport mismatch
virtio_transport_recv_listen() calls sk_acceptq_added() before
vsock_assign_transport(). If vsock_assign_transport() fails or
selects a different transport, the error path returns without
calling sk_acceptq_removed(), permanently incrementing
sk_ack_backlog.
After approximately backlog+1 such failures, sk_acceptq_is_full()
returns true, causing the listener to reject all new connections.
Fix by moving sk_acceptq_added() to after the transport validation,
matching the pattern used by vmci_transport and hyperv_transport. |
| In the Linux kernel, the following vulnerability has been resolved:
inotify: fix watch count leak when fsnotify_add_inode_mark_locked() fails
When fsnotify_add_inode_mark_locked() fails in inotify_new_watch(),
the error path calls inotify_remove_from_idr() but does not call
dec_inotify_watches() to undo the preceding inc_inotify_watches().
This leaks a watch count, and repeated failures can exhaust the
max_user_watches limit with -ENOSPC even when no watches are active.
Prior to commit 1cce1eea0aff ("inotify: Convert to using per-namespace
limits"), the watch count was incremented after fsnotify_add_mark_locked()
succeeded, so this path was not affected. The conversion moved
inc_inotify_watches() before the mark insertion without adding the
corresponding rollback.
Add the missing dec_inotify_watches() call in the error path. |
| Apache Standard Taglibs before 1.2.3 allows remote attackers to execute arbitrary code or conduct external XML entity (XXE) attacks via a crafted XSLT extension in a (1) <x:parse> or (2) <x:transform> JSTL XML tag. |
| A flaw was found in s390 eBPF JIT in bpf_jit_insn in arch/s390/net/bpf_jit_comp.c in the Linux kernel. In this flaw, a local attacker with special user privilege can circumvent the verifier and may lead to a confidentiality problem. |
|
Dell Command | Configure, versions prior to 4.11.0, contains an improper access control vulnerability. A local malicious user could potentially modify files inside installation folder during application upgrade, leading to privilege escalation.
|
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: Intel: avs: Fix unbalanced module reference count
strace_open() invokes try_module_get() which on success takes
the module reference. If any follow up operation causes
strace_open() to fail, the refcount shall be put down. |
| Fleet is an open source osquery manager. In Fleet before version 3.7.0 a malicious actor with a valid node key can send a badly formatted request that causes the Fleet server to exit, resulting in denial of service. This is possible only while a live query is currently ongoing. We believe the impact of this vulnerability to be low given the requirement that the actor has a valid node key. There is no information disclosure, privilege escalation, or code execution. The issue is fixed in Fleet 3.7.0. |
| In the Linux kernel, the following vulnerability has been resolved:
net: bcmasp: clear txcb->last before writing each descriptor
bcmasp_xmit() only wrote txcb->last = true for the final fragment
of an SKB; non-final fragments left the field untouched. If a
descriptor slot was reused while it still held a stale true from
a previous SKB (possible when tx_spb_ring_full() underreported
fullness), bcmasp_tx_reclaim() would see last == true mid-SKB and
call dev_consume_skb_any() prematurely, freeing the sk_buff while
its remaining fragments were still in flight.
Unconditionally clear txcb->last before the conditional set so every
descriptor slot starts from a known false state regardless of what a
prior transmission left behind. |
| Dependency on vulnerable third-party component in Windows Secure Boot allows an authorized attacker to bypass a security feature locally. |
| When a libcurl-based application performs transfers via `SCP://` or `SFTP://`
and utilizes the `CURLOPT_SSH_KEYFUNCTION` callback, it may silently accept an
untrusted server. This vulnerability occurs when a server presents a host key
type that does not match the specific key type already recorded for that host
in the `known_hosts` file. Instead of rejecting the mismatch, the callback
mechanism fails to properly enforce the restriction, allowing the connection
to succeed without warning and risking a potential man-in-the-middle attack. |
| libcurl would reuse a previously created connection even when some mTLS config
related option had been changed that should have prohibited reuse.
libcurl keeps previously used connections in a connection pool for subsequent
transfers to reuse if one of them matches the setup. However, some TLS
settings related to client certificates were left out from the configuration
match checks, making them match too easily. In particular options related to
the private key. |
| In the Linux kernel, the following vulnerability has been resolved:
nvme: target: rdma: fix ndev refcount leak on queue connect
nvmet_rdma_queue_connect() calls nvmet_rdma_find_get_device() which
acquires a reference on the returned ndev via kref_get(). On the path
where the host queue backlog is exceeded and the function returns
NVME_SC_CONNECT_CTRL_BUSY, reference of ndev is not released, leaking
the kref.
Fix this by adding a goto to the existing put_device label before the
early return. |
